I posted one of my jazz steel files in the "events and announcements" section, and was wondering if any of you have done much mp3 encoding.
The file I posted is a three minute stereo Mp3 file that is 3.5 MB in size after encoding at a bitrate of 160k. I'd like to get the file size down a little smaller. I have tried lower bitrate, but even 128k sounds bad, with artifacts that resemble flutter on a tape recorder.
160k sounds pretty good, but I'm wondering about variable bitrate enecoding. Do all Mp3 players support variable bitrate? Are all Mp3 encoders equal in performance?
Here's the file I posted in the other forum:
Our Delight" 3.5 MB Mp3
Mp3 encoding
Moderator: Wiz Feinberg
-
Jerry Gleason
- Posts: 1102
- Joined: 4 Aug 1998 11:00 pm
- Location: Eugene, Oregon, USA
-
Bobby Lee
- Site Admin
- Posts: 14863
- Joined: 4 Aug 1998 11:00 pm
- Location: Cloverdale, California, USA
Try knocking down your sample rate before doing the encoding. If your sample rate is 11kHz you'll lose a bit of high end, but that high end is where the most annoying MP3 artifacts occur.
Also, mixing to mono before encoding will knock the file size in half. It's a bit trickier to mix, but good mono beats warbly stereo!
------------------
<small><img align=right src="http://b0b.com/Averybob.gif" width=64 height=81>Bobby Lee - email: quasar@b0b.com - gigs - CDs
Sierra Session S-12 (E9), Speedy West D-10 (E9, D6),
Sierra 8 Laptop (D13), Fender Stringmaster D-8 (D13, A6)
Also, mixing to mono before encoding will knock the file size in half. It's a bit trickier to mix, but good mono beats warbly stereo!
------------------
<small><img align=right src="http://b0b.com/Averybob.gif" width=64 height=81>Bobby Lee - email: quasar@b0b.com - gigs - CDs
Sierra Session S-12 (E9), Speedy West D-10 (E9, D6),
Sierra 8 Laptop (D13), Fender Stringmaster D-8 (D13, A6)