Webb 614 E speaker compatibility

Ray DeVoe · Post by **Ray DeVoe** » 9 Feb 2005 2:08 pm

Hi. I just purchased my first Webb and have a question as to speaker compatibility. The back of the amp states 225 watts output at 4 ohms. The 2 speaker out jacks have written between them 2, 4, and 8, ohms. I'm sure any Webb owner can answer this. Does this amp have a circuit that changes to where it puts out the same 225 watts at whatever ohm load??

Thanks for any enlightenment that you can provide me on this. I have a JBL K 130, 8 ohm speaker that I was planning on installing.

Thanks
Ray

Jay Ganz · Post by **Jay Ganz** » 9 Feb 2005 2:16 pm

If you install an 8 ohm speaker in the Webb,
it will put out approximately 160 watts rms.
You won't notice any difference in volume, but
it will break up a little sooner when you
really crank the amp way up.

Ray DeVoe · Post by **Ray DeVoe** » 9 Feb 2005 4:20 pm

Thanks Jay for your help.

I also sent you an e mail concerning the above but with a little more detail.

Thanks again
Ray