Evans pre-amp with TubeFex..what now?

forrest klott · Post by **forrest klott** » 13 May 2004 6:58 am

Okay, finally made the plunge and found an Evans LV pre-amp at a good enough price that I can afford to experiment with running it with my TubeFex and I'm not sure what to do next!

1-Do any of you guys use these two units in conjunction?

2-If so, how are you hooking them up?

3-Once hooked up, are you editing your EQ settings out of the programs in the TubeFex, thereby just using it as an effects unit?

4-What are some good settings to start with? This is the low voltage model, and I'll be running a MosValve 1500 with it.

Any help that can be provided would be appreciated. I know the TubeFex IS a pre-amp, I just want better control over my sound if I can get it. It seems like with the TubeFex it's pretty hit or miss and I can never seem to dial it in like I want.

Thanks for the help!

Skeeter<FONT SIZE=1 COLOR="#8e236b"><p align=CENTER>[This message was edited by forrest klott on 13 May 2004 at 11:09 AM.]</p></FONT>

Mike Brown · Post by **Mike Brown** » 13 May 2004 7:21 am

I invite you to contact me toll free here at Peavey should you have questions about the Tubefex. 1-877-732-8391

Mike Brown
Peavey Electronics Corporation

forrest klott · Post by **forrest klott** » 13 May 2004 10:08 am

Thanks Mike!

Skeeter

DALE WHITENER · Post by **DALE WHITENER** » 14 May 2004 2:05 am

Forrest,
Run your Tubefex in the effects loop of the
Evans. I left my patches on the Tubefex
as they were and adjusted the Evans to taste.

Dale