Session 500 line out

Bill Ford · Post by **Bill Ford** » 19 Jan 2004 6:34 pm

Is there a way on a session500 to get the volume up on the lineout,and down on the speaker volume. I'm trying my hand at some rythem track recording and using headphones to listen to the playback on the headphone out on the recorder while I record on another track.

------------------
Bill Ford

Don Walters · Post by **Don Walters** » 19 Jan 2004 7:19 pm

Bill, if you mean "off" when you say "down", then, since the 500 is solid state, you can just unplug the speaker cable from the amp. I did that often with my 500 with no problem.

Vernon Hester · Post by **Vernon Hester** » 19 Jan 2004 11:19 pm

Bill,
I use the Session 500 pre amp out for recording and turn the master volume down to zero.This amp has a wonderful pre-amp and sometimes I will use it to feed my Lexicons and go to the mixing board from the Lexicon.Send me your address and I will mail you one of my new CD's.
Vern<FONT SIZE=1 COLOR="#8e236b"><p align=CENTER>[This message was edited by Vernon Hester on 19 January 2004 at 11:20 PM.]</p></FONT>

Bill Ford · Post by **Bill Ford** » 20 Jan 2004 5:53 am

Thanks guys,I'll give it a try...Bill

------------------
Bill Ford

Mike Brown · Post by **Mike Brown** » 20 Jan 2004 6:08 am

Thanks for your expertise, guys.

Mike Brown
Peavey Electronics Corporation

richard burton · Post by **richard burton** » 20 Jan 2004 11:13 am

Plug a jack into 'Power amp in'. This disables the speaker.