Question for Mike Brown

Richard Tipple · Post by **Richard Tipple** » 23 Dec 2003 9:15 am

Mike
I was wondering if I can purchase the Mod kit for my NV 400 from you & If you need any Info off the amp
Thanks

Mike Brown · Post by **Mike Brown** » 23 Dec 2003 9:25 am

Yes, you can purchase the Nashville 400 steel amp mod kit direct from the factory at retail cost of $29.98. However, if you have a good working relationship with your Peavey dealer, he may provide a lower price.

NOTE: All Nashville 400's were modified at the factory beginning with 08575482. Serial numbers ran consecutive at that time.

Our techs can perform this modification for you if you wish to send your chassis to the factory. It takes approximately an hour at $36.00 per hour labor charge. If other problems are found at this time, the appropriate labor charge will apply. Our address is;
Peavey Service Center
Attn; Repair Department
412 Hwy. 80 East
Meridian, MS 39301

Please include a copy of this message with your chassis.

Mike Brown
Peavey Electronics Corporation

<FONT SIZE=1 COLOR="#8e236b"><p align=CENTER>[This message was edited by Mike Brown on 23 December 2003 at 09:26 AM.]</p></FONT>

Richard Tipple · Post by **Richard Tipple** » 23 Dec 2003 8:17 pm

Thanks Mike
I was wanting to install the Mod myself, I have installed a few in the Sessions Etc.
All I need is an instruction paper with the Mod.
Is there a number I can call & order the Mod. with the old Master Card
Thanks Mike