mod's

Don Discher · Post by **Don Discher** » 1 Dec 2003 6:28 pm

Is there a difference in the Peavey Mod and the John Lemay Miracle audio Super Mod or are they the same thing ?I want to do my Nashville 400 with one or the other.

jay thompson · Post by **jay thompson** » 1 Dec 2003 8:38 pm

Don,
As I recall, about $50 American.
Regards,
Jay Thompson

Donny Hinson · Post by **Donny Hinson** » 2 Dec 2003 3:35 pm

The Peavey kit is less expensive, but I don't think it gives quite the low-end boost that the LeMay kit seems to give. If you're not into a "fat sound", go with the Peavey kit. Either one will give a substantial improvement to the stock amp.

Mike Brown · Post by **Mike Brown** » 4 Dec 2003 6:54 am

What the LeMay mod does not consider, is that too much low frequency in an opened back cabinet can cause failure of the speaker. A failure such as this is not covered under the Peavey warranty policy.

Mike Brown
Peavey Electronics Corporation

r johnson · Post by **r johnson** » 4 Dec 2003 7:17 pm

Just had the Peavey mod kit installed on my NV400 it is amazing how much difference it make in the sound. Go For It!!!

Murnel Babineaux · Post by **Murnel Babineaux** » 10 Dec 2003 10:56 pm

I install and highly recommend these upgrade components in your Peavey amp.

Check out some more info here:
http://www.cajunsteelguitar.com/id13.html

Thanks,

MB

John Lazarus · Post by **John Lazarus** » 11 Dec 2003 8:55 am

Mike Brown- How do I order the mod for a Session 400 Limited? Are there instructions included to do it myself? How much does the kit cost?
Thanks.

Mike Brown · Post by **Mike Brown** » 19 Dec 2003 6:38 am

Hello John,
Thank you for inquiring and for your support of Peavey products.

You can order the Nashville 400 Limited mod kit through your local authorized Peavey dealer or through our Parts Department here at the factory. Our number is (601)483-5365 or at parts@peavey.com

The kit number is #90500048 and carries a U.S. MSRP of $29.98 and can be installed by a qualified technician in approximately an hour's time. The kit includes a "to" and "from" parts list with location designation and an original Nashville 400 schematic. Here is a link to the kit from our website;
http://www.peavey.com/media/pdf/steelguitar/nsh400mo.pdf

It also includes a circuit board layout. If you have questions, I will be glad to answer them for you.

NOTE:ALL NASHVILLE 400'S PRIOR TO 08575462 HAD THIS KIT INSTALLED AT THE FACTORY PRIOR TO SHIPMENT.
Mike Brown
Peavey Electronics Corporation