Sm57

Paul Norris · Post by **Paul Norris** » 5 May 2003 10:47 am

I use this mike to mike my nv 400,but when I went to use it the other night it would not work. Later when I got it home ,I took it apart and all the wires were broken at the soilder points.looks like it had been taken apart.( maybe someone swaped).Does anyone have the wiring diagram so I might put these wires back on. Thanks

Brad Sarno · Post by **Brad Sarno** » 5 May 2003 12:41 pm

Are you looking at the wire points inside the mic where the body unscrews or are you looking at the xlr pin connections?

brad sarno

Paul Norris · Post by **Paul Norris** » 5 May 2003 5:10 pm

It is where the head unscrews from the body.The small black wire that is on the screw post inside is my main concern, but help with all of it is most welcome. Thanks:

Joey Ace · Post by **Joey Ace** » 5 May 2003 5:57 pm

Brad Sarno · Post by **Brad Sarno** » 5 May 2003 7:29 pm

The black wire from the center of the capsule goes into the lower part of the mic and should be soldered to that copper strip which then has a black wire that goes down all the way to pin 1 on the xlr jack. It's the ground wire. The two colored wires go to the transformer that's tucked down inside beneath the copper strip.

Brad Sarno

Paul Norris · Post by **Paul Norris** » 6 May 2003 10:40 am

Thanks guys, you have been a big help. Let me know if I can help either of you.

Joey Ace · Post by **Joey Ace** » 6 May 2003 11:42 am

You welcome, Paul.

related comment here