Profex II hook up to board ?????

Buster Warren · Post by **Buster Warren** » 30 Mar 2003 11:02 am

Can anyone tell me how to come off a profex II as a Line Out to the board ??? Emmons P/P,
Evans ESPA, Profex II, Peavy DPC 1400, Peavy Classic 115 speakers (2) . That dern Guitar picker is going through the board and he's
walking all over me !!!! Help !!

------------------
Thank's> Buster,"JAM4FUN"

Andy Zahnd · Post by **Andy Zahnd** » 30 Mar 2003 12:21 pm

try a good DI-Box! But I prefer going to the amp and mic the amp... more balls and it's more what the steelsound is all about!

Mike Brown · Post by **Mike Brown** » 31 Mar 2003 8:36 am

One of the two OUTPUTS on the right side of the rear panel can be used as a direct out if you are not using a stereo effect in the chain of effects. However, if you are operating the Profex II in a stereo setup(both LEFT and RIGHT outputs simultaneously), you can program FX into the Profex II preset chain and use the LEFT/MONO output in the effects loop output jacks, to send a direct signal to the mixing console. Of course, the parameters of that FX function would have to be setup for sufficient signal output.

If you have a question concerning this setup, feel free to give me a toll free call in the U.S. at 1-877-732-8391 and I'll be glad to assist you.

Mike Brown
Peavey Electronics Corporation <FONT SIZE=1 COLOR="#8e236b"><p align=CENTER>[This message was edited by Mike Brown on 31 March 2003 at 08:37 AM.]</p></FONT>