Sho-Bud volume pedal

Mike Black · Post by **Mike Black** » 14 Jan 2003 7:15 pm

I bought a Sho~Bud pedal that I'm going to fix up and give to my pal for his D-8 Sho~Bud. It's Ben Keith's old steel and he needs to have a matching pedal for it!
The string is missing and needs to be replaced The rest of the pedal is intact except the bottom plate is missing. Can one of you folks that owns one send me a jpg or 2 of the inside so I can see how the string is wound and anchored? I also would like to see a photo or tracing of the bottom plate. Thanks for the help.[This message was edited by Mike Black on 14 January 2003 at 07:16 PM.]

Mike Black · Post by **Mike Black** » 17 Jan 2003 8:38 pm

Still looking for a jpgs of the workings of a Sho~Bud pedal. I'll swap jpgs of Bigbsy or Fender Vol/Tone or Volume only pedals.
A picture's worth a 1000 words![This message was edited by Mike Black on 17 January 2003 at 08:40 PM.]

Jim Palenscar · Post by **Jim Palenscar** » 18 Jan 2003 8:05 am

Mike - see this article by Jeff- I have a ShoBud pedal as well and it is the same as the Goodrich, etc~ http://www.steelguitarinfo.com/other/volumepedal/pot_change.html

Bill Ford · Post by **Bill Ford** » 20 Jan 2003 3:30 pm

Mike,
Check your email
The measurements on the plate is 3"x8",the hole spaceing is 2 1/2"x7 1/2"
BF

------------------
Bill Ford[This message was edited by Bill Ford on 20 January 2003 at 04:12 PM.]