Help with Peavey Amp

Stephen Winters · Post by **Stephen Winters** » 10 Dec 2002 11:19 am

This may seem like a dumb question...but I need to ask it.

I have an old Peavey Deuce amp (2x12) that I bought a little while back. I need to take the front grill off of the amp. I know some peavey grills are attached with velcro...is this one? It seems pretty tight, and before I started applying too much pressure, I wanted to ask.

Thanks for your help.

------------------
Stephen Winters
Carter Starter
Peavey Deuce

Mike Brown · Post by **Mike Brown** » 10 Dec 2002 11:26 am

The baffle on the Deuce amps was permanent and the speakers mounted from the rear. Speakers can be removed through the rear of the cabinet.

Stephen Winters · Post by **Stephen Winters** » 10 Dec 2002 11:29 am

Thanks for the reply. But your answer leads to another question.

I need to remove the chassis and I am having a hard time. It looks like the grill is keeping the chassis from sliding out. Any suggestions?

Thanks again.

------------------
Stephen Winters
Carter Starter
Peavey Deuce

Mike Brown · Post by **Mike Brown** » 10 Dec 2002 2:56 pm

Since this particular amp has two heavy transformers, you will probably have to lift up on the chassis and remove it through the rear of the amp. Also, don't forget to remove the power cord retainer, disconnect the speaker and the reverb pan. Good Luck and thanks for using our products. Here's a link to our website if you choose to check out our latest amplifiers; http://www.peavey.com/