Mike, I just aquired this 680c and it needs some TLC. Are the knobs still availiable? Also need to know how much a schematic would cost. Also could use a parts list. You can use my email to reply if you wish. Thanks. If I don't talk to before then, may you and yours have a very Merry Christmas.
XR-680C Mike Bown
Moderator: Dave Mudgett
-
Doyle Huff
- Posts: 238
- Joined: 19 Oct 2001 12:01 am
- Location: Broken Arrow, OK USA
- State/Province: -
- Country: United States
-
Doyle Huff
- Posts: 238
- Joined: 19 Oct 2001 12:01 am
- Location: Broken Arrow, OK USA
- State/Province: -
- Country: United States
-
Mike Brown
- Posts: 5027
- Joined: 4 Aug 1998 11:00 pm
- Location: Meridian, Mississippi USA
- State/Province: Mississippi
- Country: United States
Sorry Doyle, but sometimes calling us direct is the quickest way to get an answer. E-mail is a good method for correspondance, but not always the quickest.
I check the Forum on a daily basis and can usually provide an answer about Peavey products quickly, but Mondays are always busy, therefore posting answers on the Forum is sometimes delayed. I'm glad that your situation is taken care of.
Mike Brown
Peavey Electronics Corporation
I check the Forum on a daily basis and can usually provide an answer about Peavey products quickly, but Mondays are always busy, therefore posting answers on the Forum is sometimes delayed. I'm glad that your situation is taken care of.
Mike Brown
Peavey Electronics Corporation