Nashville 400 Problems

Amplifiers, effects, pickups, electronic components, wiring, etc.

Moderator: Dave Mudgett

Will Aytes
Posts: 396
Joined: 8 May 2002 12:01 am
Location: Bartow, Florida, USA
State/Province: Florida
Country: United States

Nashville 400 Problems

Post by Will Aytes »

My amp when I turn it on makes what I call a barking noise, for the lack of a better expression, and continues on with this intermitently. If you leave it on for a while unused it will make this also.

Need Help

Will
Top
Bill Crook
Posts: 1834
Joined: 4 Aug 1998 11:00 pm
Location: Goodlettsville, TN , Spending my kid's inheritance
State/Province: -
Country: United States

Post by Bill Crook »

I would suspect that a loose conponnet,wire or molex plug is the problem.

If you were in the "Nashville" area,I would be glad to check it out for you. Generally, these pops,intermittent shutdowns,whistles are not major amp-killing problems.

A good Electronics tech in your area should be able to locate your problem without too much hunting.
Top
Mike Brown
Posts: 5027
Joined: 4 Aug 1998 11:00 pm
Location: Meridian, Mississippi USA
State/Province: Mississippi
Country: United States

Post by Mike Brown »

Hello Will,
That is a hard one to pinpoint without bench testing the unit. A guess would be that it might be related to the filter caps, but that is just a guess. Here is a link to the authorized Peavey Service Center page from our website;http://www.peavey.com/support/dealerlocator/

I'm sure that they can assist with the repair of your amp. Let me know if I can assist.

Mike Brown
Peavey Electronics Corporation
Top

Return to “Electronics”