How hard is it to install a "line out" jack?

Jeremy Steele · Post by **Jeremy Steele** » 17 Apr 2002 7:44 am

Maybe one of you tech gurus can help me on this. I have a little Ibanez amp I like to use in small venues, and I usually mic it and run it thru the PA. Would it be tough to put a quarter inch line out jack somewhere so I could just take the signal directly?

Dennis Detweiler · Post by **Dennis Detweiler** » 17 Apr 2002 11:01 am

PV makes a "EDI" box that you can plug in (between) the speaker output and the speaker. It has a XLR mic chord out, on the box to plug directly into the board.
I think they retail for about $60? I use one with my 1976 session 400. Works very well.
Dennis

Jeremy Steele · Post by **Jeremy Steele** » 17 Apr 2002 11:22 am

Thanx Dennis, I'll check it out.

Mike Brown · Post by **Mike Brown** » 19 Apr 2002 8:12 am

Hello Jeremy,
If you need further information concerning the use and specs of the Peavey EDI box, I'll be glad to assist. In the meantime, here is our authorized dealer link from the Peavey website;http://www.peavey.com/support/dealerlocator/

In the meantime, I can be reached at 1-877-732-8391 should you need further information about this or any Peavey product.

Mike Brown
Peavey Electronics Corporation

Donny Hinson · Post by **Donny Hinson** » 20 Apr 2002 12:28 pm

Any competent technician can do this. And if he has a schematic of the amp, it's a very quick and simple operation. If you're having it done, I'd have them install a level control for the line-out jack as well.