Nashville400/RV3 Settings

Chris Caruso · Post by **Chris Caruso** » 3 Mar 2002 6:16 pm

Any suggestions on the reverb settings on the Nashville 400 and the RV3 settings when used together. I just picked up the RV3 and need a good starting point. (After plugging it in)!!!

------------------
D-10 Fessenden

Jim Cohen · Post by **Jim Cohen** » 3 Mar 2002 8:06 pm

Hey, Chris. When I use my RV3 with my Nashville 400, I just use the delay part on the RV3 and use the reverb of the NV400. Of course, you gotta see what sounds best to your ear, so your mileage may vary!
See ya at the shows, pal!
Jim

Joey Ace · Post by **Joey Ace** » 4 Mar 2002 1:28 pm

I use a RV-3 set to "Lloyd Specs"
Setting #7 which is plate 'verb + delay
Mix - 7:30/8:00 o'clock
Feedback - 11 o'clock
Delay Time - 1 o'clock

into a Nash 400
(with Nash's Reverb set to ZERO)

Ron Randall · Post by **Ron Randall** » 4 Mar 2002 6:24 pm

Ditto.
No reverb on N400.
If the reverb is too much, back it down to 4,5,or 6.

Great unit.

Chris Caruso · Post by **Chris Caruso** » 5 Mar 2002 6:34 pm

Thanks for the info. Should I put it in line between the pedal and the amp or use the effects patch on the amp?

Joey Ace · Post by **Joey Ace** » 5 Mar 2002 6:54 pm

I use the rear effects patch, small patch cables, the RV-3 sets on top of the amp.
I only turn it off to tune.

I once tried it into the front standard input. I didn't notice a difference.