Can someone give me the key strokes to set the output levels on the tube fex. ie CM=100 etc. I have done it before, but l lost the proceedure. I'm going nuts trying to solve it and l am sure that it is something simple that l forgot. Old age is wonderful!!!
Thanks
tube fex
Moderator: Dave Mudgett
-
mtulbert
- Posts: 1593
- Joined: 14 Apr 2000 12:01 am
- Location: Plano, Texas 75023
- State/Province: Texas
- Country: United States
-
George Erickson
- Posts: 8
- Joined: 5 Apr 2000 12:01 am
- Location: Ipswich, MA USA
- State/Province: -
- Country: United States
-
George Erickson
- Posts: 8
- Joined: 5 Apr 2000 12:01 am
- Location: Ipswich, MA USA
- State/Province: -
- Country: United States
Hi Guys
Eureka!!
The output level of any of the effects can be programmed by placing the cursor under the arror or + sign located between effects. Then press edit and the effect preceeding the arrow or + can be changed by using the up/down arrows.
You will not find these info in the manual & l don't know why.
Anyway that problem is resolved.
Eureka!!
The output level of any of the effects can be programmed by placing the cursor under the arror or + sign located between effects. Then press edit and the effect preceeding the arrow or + can be changed by using the up/down arrows.
You will not find these info in the manual & l don't know why.
Anyway that problem is resolved.
-
Mike Brown
- Posts: 5027
- Joined: 4 Aug 1998 11:00 pm
- Location: Meridian, Mississippi USA
- State/Province: Mississippi
- Country: United States