Super Bro

Jim Johnson · Post by **Jim Johnson** » 14 Sep 2002 7:33 am

Just obtained a Super Bro and need directions
on how to set both knobs whether in dobro
sound or regular steel sound.
thanks in advance,
Jim

Gene Jones · Post by **Gene Jones** » 14 Sep 2002 9:31 am

Jim, when you want to play steel, turn the Super-Bro switch to OFF and the controls are not active because it completely by-passes the Super-Bro.

As for the "dobro" sound....the beauty is in the "EARS" of the beholder! Adjust that sucker to where the sound pleases YOU!

www.genejones.com

Jim Smith · Post by **Jim Smith** » 14 Sep 2002 9:52 am

Setting the knobs at 10:00 and 2:00 is a good place to start.

Jim Johnson · Post by **Jim Johnson** » 14 Sep 2002 11:30 am

Thanks a lot Guys,
Jim

Tom Ward · Post by **Tom Ward** » 18 Sep 2002 1:55 am

Jim, when you switch on the Super-Bro be sure you turn off any delay or reverb on your amp. Mine also works best at 10 o'clock and 2 o'clock. If you want to experiment, try using a piece of dowel rod or cut the end off of a broom stick for the bar...just for fun. You will get a different sound! Tom

George Kimery · Post by **George Kimery** » 18 Sep 2002 5:01 am

On my Match-Bro, I installed a 2nd 1/4" jack on the bottom where the regular out jack is located. When I had a delay unit that had a footswitch control, I had a cord running from this extra out jack to the footswitch in jack on the delay unit. I then wired it into the on/off switch for the Dobro sound. When, I switched the switch on the Matchbro to Dobro, it automatically cut off the delay unit.