Has anyone changed out the pedal or knee lever "cross rod" on a Stage One steel guitar?
I understand the bell cranks are permanently attached to the cross rod on the factory equipped model, there by not allowing
for any copedent change.
I'm only considering changing a couple cross rods. Maybe adding a movable bell crank to the existing cross rod and abandoning/bypassing
the current bell crank would be feasible?
Stage One "cross rod/bell cranks"
Moderator: Dave Mudgett
-
Tom Campbell
- Posts: 1819
- Joined: 8 Jun 2001 12:01 am
- Location: Houston, Texas, USA
- State/Province: Texas
- Country: United States
-
Mike DiAlesandro
- Posts: 1921
- Joined: 8 May 2010 7:36 am
- Location: Kent, Ohio
- State/Province: Ohio
- Country: United States
Re: Stage One "cross rod/bell cranks"
I have made "clip-on" bell cranks out of 6061 aluminum. They simply attach/clamp on with the 2 parts around the cross shaft so as no removal is required.
And.. Here is a reversing system I designed to lower string 6 a full tone on RKL...
And.. Here is a reversing system I designed to lower string 6 a full tone on RKL...
You do not have the required permissions to view the files attached to this post.